(a) A nonûgrounding-type receptacle(s) shall be permitted to be replaced withĪnother nonûgrounding-type receptacle(s). Receptacle enclosure, the installation shall comply with (D)(3)(a), ![]() ![]() (3) Nonûgrounding-Type Receptacles Where grounding means does not exist in the The accompanying diagram shows a ground wire going from the protected outlet back to the ground bar in the main breaker panel.ĭoes this mean what I tend to think it means – that I cannot use this to protect duplex outlets on the circuit that do not have an equipment grounding conductor running back to ground? Arrgh!!! If so, does anyone know of a reduced size GFCI that might fit into a reduced size outlet box? The instructions state “To be installed only on a single phase 120/240 VAC grounded system”. I brought the kitchen, one of the bathrooms, and one wall of the living room up to current code.įor those outlets I did not replace, the outlet boxes are so small that I was not able to squeeze a GFCI outlet into them, so I bought some GFCI breakers for those circuits figuring I could then use duplex outlets on the circuits (with appropriate labels) without having an actual ground wire run.Īs I was just starting to install the GFCI, I actually read the instructions. ![]() The originals had no grounds except for a couple of grounded outlets in the kitchen that were grounded to the water pipe. I replaced several wall outlet circuits in my circa 1957 ranch style house.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |